Your cart is empty

LPC2148 ARM 7 NXP Development Board

  • Model: LPC2148-ARM-BB
  • Units in Stock: 8
  • Manufactured by: Graylogix

Rs2200

BlueBoard-LPC214X is an evaluation board for LPC2148 ARM7TMDI based microcontroller. The LPC2148 microcontroller has 512KB of internal flash and 32+8K RAM. Following are the salient features of the board.

  • Dimensions: 112 X 122 mm2
  • Two layer PCB (FR-4 material)
  • Power supply: DC 9V with power LED
  • On-board linear regulators generate +3.3V/500mA and +5v/500mA from power supply.
  • USB connector (as alternate power source).
  • Connectors:

Extension headers for all microcontroller pins. RS232 connectors (2).

PS/2 connector. JTAG connector.

SD/MMC connector.

USB B-type connector with Link-LED.

  • Other Peripherals:
  • 512Kb I2C based EEPROM Audio power amplifier.
  • 2 line X 16 character LCD with back light control.
  • Configurable for manual and automatic program download (ISP) via serial port. 8 controllable LEDs on SPI using 74HC595.
  • User Interrupt, ADC, Buzzer, RTC.

2:  System Requirements:

  • Windows XP & Win 7
  • Serial or Parallel port
  • USB port

3: Starting off & connecting the hardware:

After unpacking the LPC2148 board connect a DC supply of 9V/1A to the DC jack to power the board. The LPC2148 board can also be powered through USB.

4: Programming LPC2148 Board:

LPC2148 Board can be programmed through serial port UART “0” using “LPC2000 flash utility V2.2.2” is a freeware windows utility used to download the hex file format onto the LPC2148 Board. If your PC does not have a serial port; use a USB to serial converter to download the hex file.

  • Programming LPC2148 Board through ISP.

The LPC2148 Board can be programmed through ISP in two modes: 1. Auto Mode 2. Manual Mode

  1. Auto Mode:

To program in Auto mode you need a full serial cable with DTR & RTS. (Recommended not to use Auto Mode).

  1. Manual Mode:

To program in Manual mode you need a half serial cable (which just has TX, RX and GND wire connected). And connect the half serial cable to UART0 and power the board. (Recommended mode)

  • Open LPC2000 Flash Utility V2.2.2
  • Browse File name and Select the hex file to be downloaded.
  • Select Device as LPC2148
  • Set XTL Freq [KHz] to 12000
  • Blank Check: Entire Device
  • Select the appropriate com port (See your “device manager” to find out the com port number)
  • Select the Baud Rate in between 9600 and 38400
  • Uncheck “Use DTR/RTS for Reset and Boot Loader Selection”
  • Click on Read Device ID.

To make the board enter programming mode

  • Hold down ISP and RESET Buttons, then release RESET first and finally ISP.
  • The controller enters the bootloader mode.
  • It will display as “Read device ID Successful”.
  • Click on the Upload to Flash Button.
  • Program uploaded successfully.
  • Click the Rest Button on the Board. That’s it, your hex file is on the board.


Download LPC2148 CD


Add to Cart:




This product was added to our catalog on Friday 13 November, 2015.