Your cart is empty

PIC kit 3

  • Model: PIC kit 3
  • Shipping Weight: 0.1lbs
  • Units in Stock: 96
  • Manufactured by: Graylogix

Rs4000  Rs1200
Save: 70% off

The PICkit 3 programmer/debugger is a simple, low-cost in-circuit debugger that is controlled by a PC running MPLAB IDE (v8.20 or greater) software on a Windows platform. The PICkit 3 programmer/debugger is an integral part of the development engineer's tool suite. The application usage can vary from software development to hardware integration. The PICkit 3 programmer/debugger is a debugger system used for hardware and software development of Microchip PIC microcontrollers (MCUs) and dsPIC Digital Signal Controllers (DSCs) that are based on In-Circuit Serial Programming? ICSP) and Enhanced In-Circuit Serial Programming 2-wire serial interfaces. In addition to debugger functions, the PICkit 3 programmer/debugger system also may be used as a development programmer. The PICkit 3 programmer/debugger is not intended to be used as a production programmer. The debugger system executes code like an actual device because it uses a device with built-in emulation circuitry, instead of a special debugger chip, for emulation. All available features of a given device are accessible interactively, and can be set and modified by the MPLAB IDE interface. The PICkit 3 debugger was developed for emulating embedded processors with debug facilities.

The PICkit 3 features include:
  • Full-speed USB support using Windows standard drivers
  • Real-time execution
  • Processors run at maximum speeds
  • Built-in over-voltage/short circuit monitor
  • Low voltage to 5V (1.8-5V range)
  • Diagnostic LEDs (power, active, status)
  • Read/write program and data memory of microcontroller
  • Erase of all memory types (EEPROM, ID, configuration and program) with verification
  • Peripheral freeze at breakpoint


Download UserManual

Add to Cart:




This product was added to our catalog on Sunday 07 January, 2007.