Your cart is empty

MQ9 - Carbon Monoxide Cumbustilbe Gas Sensor Module

  • Model: MQ9 Module
  • Units in Stock: 40
  • Manufactured by: Graylogix

Rs350

Sensitive material MQ-9 gas sensor is used to clean the air in the lower conductivity of tin dioxide (SnO2). Detection method using low temperature cycling (1.5V heating ) to detect carbon monoxide, conductivity sensors with carbon monoxide in the air increased with increasing gas concentration , spurious adsorption at high temperatures (5.0V heating ) detection of combustible gases methane, propane and cryogenic cleaning gases. Simple circuit can be used to change the conductivity , concentration of the gas is converted to the corresponding output signal. MQ-9 high gas sensor for carbon monoxide, methane , liquefied petroleum gas sensitivity , the sensor can detect a variety of gases containing carbon monoxide and flammable , is a low-cost sensors for a variety of applications .

Suitable for home or factory gas leakage monitoring devices , monitoring devices suitable for carbon monoxide and other combustible gases , carbon monoxide can be tested 10 to 1000ppm CO, combustible gas range 100 to 10000ppm
Module Features :
1 , using high-quality dual-panel design, with power indicator and TTL signal output instructions;
2 , the switching signal having a DO (TTL) output and analog output AO ;
3, TTL output valid signal is low . ( Low-level signal when the output light can be directly connected to the microcontroller or relay module )
4 , the higher the voltage of the analog output voltage with concentration higher .
5 , for the carbon monoxide detector has good sensitivity.
6 , there are four screw holes for easy positioning ;
7 Product dimensions : 32 (L) * 20 (W) * 22 (H)
8 , has a long life and reliable stability
9 , rapid response and recovery characteristics
Electrical properties:
Input voltage : DC5V Power consumption ( current ): 150mA
DO output : TTL digital 0 and 1 ( 0.1 and 5V)
AO output :0.1-0 .3 V ( relative to pollution ) , the maximum concentration of a voltage of about 4V
Special note: After the sensor is powered , needs to warm up around 20S, measured data was stable , heat sensor is a normal phenomenon , because the internal heating wire , if hot is not normal .

Add to Cart:




This product was added to our catalog on Wednesday 21 September, 2016.