Your cart is empty

High-Power 43Amp Motor Driver Module BTS7960

  • Model: BTS7960-MOTOR-DRIVER
  • Units in Stock: 9

Rs1000

Product Description

This driver uses chips BTS7960 composed of high-power drive full H-bridge driver module with thermal over-current protection. Double BTS7960 H-bridge driver circuit, with a strong drive and braking, effectively isolating the microcontroller and motor driver! High-current 43A

Product Features:
  • Double BTS7960 large current (43 A) H bridge driver
  • 5V power indicator on board
  • voltage indication of motor driver output end
  • can solder heat sink
PIN Definition:
1. RPWM: Right Turn PWM
2. LPWM: Left Turn PWM
3. R_EN: Right Turn Enable (High Active)
4. L_EN: Left Turn Enable (High Active)
5. R_IS: Right Turn Current Warning (May Leave Floating)
6. L_IS: Left Turn Current Warning (May Leave Floating)
7. VCC: (5V)
8. GND
Connections:
Method 1:
VCC: 5V from Microcontroller(MCU)
GND: GND from Microcontroller(MCU)
L_PWM: PWM or 5V from Microcontroller(MCU) for CCW(CW) Turns
R_PWM: PWM or 5V from Microcontroller(MCU) for CW(CCW) Turns
R_EN and L_EN: 5V from Microcontroller(MCU)
Method 2:
VCC: 5V from Microcontroller(MCU)
GND: GND from Microcontroller(MCU)
L_PWM: 5V from Microcontroller(MCU) for CCW(CW) Turns
R_PWM: 5V from Microcontroller(MCU) for CW(CCW) Turns
R_EN and L_EN: PWM from Microcontroller(MCU)

Just need four lines from MCU to driver module (GND. 5V. PWM1. PWM2)
isolation chip 5 V power supply (can share with MCU 5 V)
size: 4 * 5 * 1.2 cm
Able to reverse the motor forward, two PWM input frequency up to 25kHZ
two heat flow passing through an error signal output
isolated chip 5V power supply (can be shared with the MCU 5V), can also use the on-board 5V supply
the supply voltage 5.5V to 27V

Add to Cart:





This product was added to our catalog on Monday 29 January, 2018.